TEC ECR Programming
TEC Required Programming
By default TEC registers are set up to communicate with a baud
rate of 9600.
Some registers require a PC board installation for communication. It is HIGHLY
recommended that you have a cash register dealer perform these operations.
TEC 1535
In order to separate totals from multiple 1535 registers users should set a
unique Terminal No. on each register
-
Turn the key to Set mode
-
Enter [4][0] [#/NS]
-
Enter the Network Terminal No. [AT\TL] [#/NS] (00 to 08)
Note: Leaving the Terminal No. set at 00 will allow
the software to send PLU changes only
TEC Modem Setup
Back to
Appendices/Cabling home
|
