SHARP Modem Setup
Host (PC Side)
The modem at the PC should work with the default Windows setup. If
there are problems, try setting the maximum baud rate of the modem to the baud
rate of the register.
Register (ECR side)
AT&F$SBXS0=NQ1&WO Where x = baud rate (ex. 9600), N = number of rings
for auto answer, and 0=zero
The separate AT commands are:
- AT&F - Restore all the factory default settings from the ROM
- AT$SBX - Serial Port Baud Rate = X (9600 for 9600 ECR settings)
- ATSO=N - Ring Count = N (number of rings before modem answers)
- ATQ1 - Result codes suppressed (quiet) including the ‘OK’
- AT&W0 - Store configuration in NVRAM to be loaded at power-up or with
the ATZ command
This is used to configure modems purchased from PC/POLL SYSTEMS. Fax any
questions to our Support Department if necessary.
Note: Extensive testing has been done on the modems sold by PC/POLL
SYSTEMS to insure that this configuration will work with PC/POLL SYSTEMS
software. If modems are purchased from another vendor, contact that vendor if
problems occur.
Sharp Communicating and Reporting
Back to
Appendices/Cabling home
|
