SHARP ECR Programming

SHARP Required Programming

During the initial setup of the SHARP registers, the Machine Number, Terminal Number, Baud Rate and Polling Port must be programmed at the register.  The Store Number, Machine Number and Baud Rate entered in the Machine Information Table in the software must match those entered into the register. It is HIGHLY recommended that you have a cash register dealer perform these operations.

Terminal Number, Baud Rate and Polling Port
Sharp 410/420
Port Designation
Turn the key to PGM2
Enter 2690 + decimal point + @/For + 1 + @/For + 1000(port 1) + Subtotal + Cash
Or
Enter 2690 + decimal point + @/For + 1 + @/For + 8000(port 2) + Subtotal + Cash
Baud Rate
This register's baud rate defaults to 19,200
Sharp 450
Port Designation
Turn the key to PGM2
Enter 2690 + decimal point + @/For + 1 + @/For + 1000(port 1) + Subtotal + Cash
Or
Enter 2690 + decimal point + @/For + 1 + @/For + 8000(port 2) + Subtotal + Cash
Baud Rate
This register's baud rate defaults to 9,600
Sharp 550
Port Designation
Turn the key to PGM2
Enter 945 + decimal point + @/For + 1000(port 1) + Cash
Baud Rate
This register's baud rate defaults to 9,600

Sharp 600/700
Port Designation
Turn the key to SRV mode
Select System Preset
Select Online and set your channel number
Baud Rate and Terminal No.
Turn the key to PGM2 mode
Select Online Setting
Set the first option for your terminal no. and set the fourth option for
your baud rate.
Machine Number
Enter PGM2 mode
Select Setting
Select Terminal
Select Machine# and set the machine#

Sharp 750, 770, 3300 & 3301
Port Designation
Enter SRV mode
Select Setting
Select Device Assign
Select Online
Set the first option for your terminal no. and set the second option for your channel no.
Baud Rate and Terminal No.
Enter PGM2 mode
Select Online Setting
Set the first option for your terminal no. and set the fourth option for your baud rate
Machine Number
Enter PGM2 mode
Select Setting
Select Terminal
Select Machine# and set the machine#


EPROM Version
One of the first thing needed in Polling is your EPROM version.  To find the EPROM version in your SHARP register, do the following:

• Make sure the register is in PGM2.
• Press 959, @/For key, then Cash and the EPROM will print on the receipt tape or appear on the screen depending on the register.

SHARP Modem Setup

Back to Appendices/Cabling home