Version 7 Register Setup: Sam4s
7000/7040/SPS2000
Below are some basic instructions for setting up a register for
communications with V7. These steps should only be completed by a
certified cash register dealer. In order to set up communications,
dealers must first program the register to allow communications, connect the
register to the PC, and configure the software. Below are instructions
on programming the register, sample cable diagrams to help dealers connect
the register to the PC, and basic installation instructions for the
software.
Register
Programming:
To program the Sam4s 7000/7040/2000, dealers should set
the following options within S-Mode:
- Set your Serial Port Device Selection
area to have port 1 or port 2 set to Polling. (All serial ports
on the SPS2000 can be used for communications.)
- Set the designated serial port to
communicate at a 9600 baud rate. (The SPS2000 can communicate up to
115200.)
- Within System Options set your Store
Number and IRC range.
On the Sam4s 7000/7040, PC/POLL is not
recommending communications with registers with a ROM less than 1.24 and a MICOM chip less than 1.06. If your registers have lower versions of
either chip please update.
Cabling:
The cabling specifications for V7 and the
Sam4s registers are identical to V6 and the Sam4s 6500. Sam4s 7000/7040
diagrams can be used on the SPS2000.
Software Setup:
To set up the software, follow the steps
below:
- Download V7 Polling from www.pcpoll.com or if you ordered a CD click
on the V7 Install button.
- Locate and run the file you just downloaded: v7install.exe. (Skip
this step if you have a V7 CD.)
- Click the Next buttons and fill in the required information
on the install screens to install the software.
- Print off or write down your registration information. (This
information will be displayed during the installation.)
- Click Finish to complete a successful installation.
- Contact Sales2007@pcpoll.com
for a release code. Be sure to include your registration
information from step 4.
- Open the software, by double-clicking on the V7 Polling icon, and
select Polling from the program selector.
- Enter in your release code and click the Update Release Code
button.
- Click the Close button on the release code screen.
- Read/view one of the following documents to learn how to use the
software.
| V7 Documentation |
| a) Click on the Help button in the lower right corner of the V7 Polling
screen. |
| b) View our online tutorials on:
www.pcpoll.com/demo/V7_demo. |
| c) If you ordered a CD, view the tutorials on your installation CD. |
|
