Appendix B - ECR Programming

CRS 3000 Required Programming

During the initial setup of the CRS 3000, the Store Number, Machine Number, Baud Rate and Polling Port must be programmed into the register. The Store Number, Machine Number and Baud Rate entered in the Machine Information Table in the software must match those entered into the register.

Store Number, Baud Rate and Polling Port

The Store Number, Baud Rate and Polling Port are programmed in P-Mode Programming.

Enter P-Mode by turning the register key.

Select <9> - RS232C Config
Select <4> – PC-Modem Port

Enter the Baud Rate.
Enter the Store Number.
Hit Escape to go back to the Main Menu.

Machine Number

The Machine Number is also programmed in P-Mode Programming.

Select <4> – System Option
Enter the Register Number and IRC Information.
Hit Escape to go back to the Main Menu.

The Register should now be ready for communications.

Note: When setting up the PC for communications, make sure the ROM version matches what is in the register. To check this, press the <X/TIME> key on the register in REG mode. The register will now display the correct version.

Appendix C -- Export Formats

Back to Appendices/Cabling home